This EPDM single-ply roofing membrane was approximately ten years old and at the time of the job leaks were quite minimal. The customer primarily wanted a coating system to help cut down on the heat within the building and to prevent future degradation of the membrane.
We cleaned the membrane using 3,000 psi of pressure to remove ten years of dirt and pollution collected on the roof. We sprayed fabric bond over the entire membrane to make sure the top coats would adhere without any problems. With very little leaks problems we only had to install a polyester fabric in a couple of places of concern and did so using a quality butyl to adhere the fabric to the membrane.
At that point we applied two coats of our bright white, liquid applied butyl roof coating to the entire roof area to form a seamless elastomeric membrane that will last for at least ten years.
Choose another roof type below to see the dramatic difference Southeastern Coatings can make on your roof: